Workholding
Systec Pneumatic Power Chucks Feature Cast Clamp Times
Lexair’s Systec self contained pneumatic power chuck features fast clamp and unclamp times, the bodies are steel that has been hardened to a 62 HRC and precision ground and internal safety valves prevent the loss of air pressure and grip force.
Read MoreRota NCR Six-Jaw Chuck Distributes Clamp Force
Schunk’s six-jaw Rota NCR chuck can be used for thin-walled or deformation-sensitive parts. Rough castings or rings can be centered with minimal distortion to the workpiece.
Read MoreVise Features Ultra-Low Profile Clamping with TG GrigSert
Fixtureworks’s Kurt DX6 CrossOver vise, with TG GripSert jaws and gripper inserts, provides improved bearing pack, all-directional alignment and a reduction in jaw lift and features a lighter weight nut and a new brush seal design.
Read MoreStationary Collet Workholding Components Group Together
Lexair Inc. can custom design and build turnkey solutions for any workholding application.
Read MoreUniflex Clamping System Designed to Hold Uneven Parts
Big Kaiser’s Uniflex 3D zero-point clamping system provides vibration-free holding of the part when multiple clamping is used and has low-wear against tools.
Read MoreKontec KSC-F Vise Achieves High Clamping Forces
Schunk’s Kontec KSC-F single-acting clamping vises can be actuated by a standard hexagon connection using either conventional socket wrenches, extensions, or torque wrenches.
Read More18” Diameter Boring Rings Provide Uniform Pressure on Jaws
Dillon Chuck Jaws’s 18” diameter boring ring is relatively lightweight, allows soft jaws to be machined precisely and grip the intended workpiece more firmly, and provide uniform pressure on all jaws for a consistent bore.
Read MoreMagnos Technology Has Uniform, Deformation-Free Clamping
Schunk’s Magnos magnetic clamping technology is composed of parallel pole, square pole, and radial pole plates that boost productivity by up to 200 percent compared to conventional solutions using parallel pole technology.
Read MoreWhizHold Workholding Line Sets Up Swiss-Type Lathes
WhizCut’s WhizHold line is a range of toolholding and workholding products developed for Swiss-type lathes that can set up a Swiss lathe with precision tools as collet holders, collets and revolving ends.
Read MoreSoft Blank Jaws Provide Part Clamping
Dillon’s soft jaw blanks feature reduced setup times, aid concentric performance, provide better chuck balance, and have a longer jaw life because of the increased jaw accuracies.
Read More